How can I disable Juggernaut Firewall from the command line?

You can disable and enable the firewall from the command line using the following commands:

To disable the firewall:

csf -x

To re-enable the firewall:

csf -e

To get the list of all command line options:

csf --help
  • disable, cli
  • 1 Users Found This Useful
Was this answer helpful?

Related Articles

Can I use Juggernaut Firewall to block Wordpress bruteforce attacks?

Yes we support blocking attacks like these very easily. See the howto for how to enable a custom...

How can I raise the open file limit for the login failure daemon?

The login failure daemon can crash if you are monitoring a lot of domains in Plesk and are...

How can I test to make sure that the OS has all the required kernel modules required for Juggernaut Firewall?

Test from the Juggernaut Extension You can run the firewall test by going to Juggernaut Firewall...

How can I only allow SSH from my IP address and block it on the firewall for everyone else?

First make sure that your IP address is whitelisted on the firewall so you do not accidentally...

How can I adjust the attack triggers used by the login failure daemon?

To Adjust Login Failure Triggers Navigate to Juggernaut Firewall -> Settings -> Login...