How can I fix the error: The VPS iptables rule limit (numiptent) is too low?

This error means that your service provider is limiting the amount if iptables rules (numiptent)  that your VPS is allowed to create. Your provider can easily raise this limit using the command below on the hardware note (it can't be run inside your VPS). If your provider refuses to raise this limit then it's time to look for a new service provider as they do not really care about your security.

vzctl set CID --numiptent 5000 --save

Users using Virtuozzo with a limit set will not be able to use the country or blocklists as they will usually put them over their limit.

  1. Users can limit the amount of rules that Juggernaut will create by setting the deny permanently limit and deny temporarily limit under Juggernaut -> Settings -> General Settings. Juggernaut will rotate out older entries to stay under the limit set unless the entry is marked with "do not delete".
  2. You can also try to limit the number of iptables rules used for country block lists under Juggernaut -> Settings -> Country Settings -> Ignore CIDR blocks smaller than (set it to something like /24). This will allow you to still block the majority of the country while ignoring the smaller networks.

Note
Virtuozzo is not the ideal VPS because it does not support ipset for high performance firewall blocking. Most of the larger VPS providers like OVH, Digital Ocean, and Linode have long switched away from using Virtuozzo and now use KVM which fully supports ipset. Even Virtuozzo themselves have switched over to using KVM in Virtuozzo 7.

  • numiptent, virtuozzo
  • 0 Users Found This Useful
Was this answer helpful?

Related Articles

Can I use Juggernaut Firewall to block Wordpress bruteforce attacks?

Yes we support blocking attacks like these very easily. See the howto for how to enable a custom...

How can I fix the error: The domain limit of this license key has been reached?

The admin and pro versions of our products are limited to the number of domains you can have in...

How can I disable the logging of iptables to the console?

To permanently disable all low level kernel messages (iptables etc) from flooding the console do...

How can I disable the firewall from the command line?

You can disable and enable the firewall from the command line using the following commands:To...

I get the a 502 gateway error when clicking on the application. How can I fix this?

This can usually be fixed by just restarting the Plesk interface:/etc/init.d/psa restart